Paver Calculator
Paver count, base gravel and bedding sand in one pass — the whole patio, not just the brick count.
Please check your inputs — values must be within the allowed ranges.
How to calculate pavers
- Patio area = length × width (sq ft)
- In square inches: area × 144
- Raw count = area in sq in ÷ one paver's face area (sq in)
- Add waste: × 1.05 for straight patterns, × 1.10 for diagonal or herringbone, then round up
Example — a 12 × 12 ft patio with 4x8 pavers (32 sq in each): 144 sq ft × 144 ÷ 32 = 648 pavers, × 1.05 = 681 pavers.
Common paver size chart
| Paver (in) | Face area | Pavers per sq ft | 100 sq ft (with 5% waste) |
|---|---|---|---|
| 4 × 8 | 32 sq in | 4.5 | 473 |
| 6 × 6 | 36 sq in | 4.0 | 421 |
| 6 × 9 | 54 sq in | 2.67 | 281 |
| 12 × 12 | 144 sq in | 1.0 | 105 |
| 16 × 16 | 256 sq in | 0.56 | 60 |
Nominal sizes vary by manufacturer — a "4x8" brick may measure 3⅞ × 7¾ in. Check the actual face size on the spec sheet; the calculator uses the nominal values above.
Pattern waste guide
| Pattern | Waste to add | Why |
|---|---|---|
| Stack bond (grid) | ~5% | Few cuts, but every cut piece at edges is a full-brick shape |
| Running bond (brick offset) | ~5% | Half-offsets reuse cut pieces efficiently |
| Diagonal | ~10% | Every edge paver gets two angled cuts |
| Herringbone | ~10% | Angled layout, most cut waste of the common patterns |
Base layers explained
Pavers sit on a layered base — the hidden part that decides whether your patio stays flat:
- Base gravel (crushed stone): 4 in for walkways and patios, 6 in for driveways or soft soil. Compacted in 2-in lifts.
- Bedding sand: 1 in on top of the gravel — just enough to seat the pavers, never more.
- Edge restraint + joint sand: perimeter restraint and polymeric sand swept into the joints lock everything in place.
The calculator outputs gravel and sand volumes for your area — about 1.54 cu yd of gravel and 0.31 cu yd of sand for a 12 × 12 ft patio at 4-in base.
For layer-thickness standards, see the ICPI (Interlocking Concrete Pavement Institute) guides.
Sources & assumptions
- Paver math (area × 144 ÷ face area × waste): plain geometry.
- Base layer thicknesses (4–6 in gravel, 1 in sand): standard residential practice per ICPI guides.
- Pattern waste (5% straight, 10% angled): common contractor allowances.
- Nominal paver sizes (4x8 = 32 sq in etc.): industry-nominal dimensions — verify the actual face size on your product's spec sheet.